Caution: Before doing any work on the dryer, make sure it's unplugged. If there are no problems with the motor, switches, or electrical system, this should restart the dryer. If the motor won't run, let the dryer cool for about ten minutes. Many dryers are equipped with a reset button on the control panel. Unless the door is properly closed, the dryer won't work, regardless of the settings on the control panel. The temperature and speed of the drum are controlled by a series of thermostats operated from a timer device on the control panel of the dryer.Īs a safety device, a dryer usually has a door switch that activates the working parts. Air heated by a gas heater or electric heating element is blown through the drum to dry the laundry. A motor with pulleys - connected by a series of belts - turns the drum. Francesco Carta fotografo / Getty ImagesĪ dryer is simply a large drum into which wet laundry is loaded. Push the bearing into place until it is flush with the tub.Repairing a dryer is easy if you follow the proper steps. Place the new tub bearing in the inner tub. Wipe the inner tub clean with paper towels. After several minutes have past, remove the bearing with a socket wrench. Saturate the bolt securing the old bearing to the inner tub with lubricant. Remove the inner tub from the outer drum by lifting it up and out. Pull the top half off the bottom half and set next to each other. Remove the screws that hold the drums two halves together. Place the drum face first on a blanket spread out on the floor. The Frigidaire washer cabinet should be empty. Remove the drum from the rear of the cabinet. Repeat this on the other corner of the drum. This will disconnect the spring frame from the drum. Lift one corner of the drum up and toward the center before lowering the drum. Remove the clip holders securing the drum to the springs. The washer drum will now hang from a set of springs. Remove the glue near the seal on the front panel by carefully scrapping it with a utility knife. Disconnect the tubs running from the top part of the outer tank. Place pieces of wood underneath the drum to support the drum weight. Slide the pins out of the washer tub and remove the shocks. Press in on the lock tabs to release the shock pins. Move the board and motor out of the washer cabinet. Remove the screws that are holding the motor control board and pump motor in place. Disconnect the connector that is attached to the pump motor. Step 7ĭisconnect the connectors that are attached to the control board of the motor. Gently pull the water level switch hose off. Apply pressure to the snap rings until they loosen their grip on the water level sensor and you can set this sensor to the side. Step 6įind the snap rings that secure the water level sensor to the washer. Loosen the screw securing the trap and remove it from the washer. Locate the rubber drain trap, which is typically to the right. Carefully lift the loosen motor out of the cabinet and set to the side. Locate the four bolts that secure the motor and remove them with a socket wrench. Unplug the motor and let the wires hang down toward the bottom of the washer. Use a utility knife to cut the wire tie securing the motor whiles together. Slip the drive belt carefully off and set it out of the way.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |